00462166 Frigidaire Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Arthur from LUTZ, FL
- Parts Used:
- 5304509460
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Microwave tripped circuit breaker when turned on
Remove vent cover then remove touch screen control panel. When you remove control panel take photo of where everything is plugged in then unplug and remove control panel. 3 door switches located next to door in a plastic chassis. Test each switch with current tester. Remove the bad switch and replace with the new one. You tube DIY helped.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JOSEPH from MIAMI, FL
- Parts Used:
- 5304509457
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Power would not come on, would trip breaker when connected.
First thing I dir was search YouTube for any related videos and found this one https://www.youtube.com/watch?v=uHj4H9Fdxrc, it was the exact problem my microwave was exhibiting. Once I verified the problem by troubleshooting, I removed the part and verified that the switches were working fine, the door latch assembly showed signs of wear which was the cause of the problem. After receiving the replacement part I installed it, verified that power was restored to the unit and reassembled the microwave, works fine, hope it lasts a long time!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ARNEL from WAUKEGAN, IL
- Parts Used:
- 5304509460
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Pressing the start, microwave will start and dies out. Electric is tripping.
The diagnosis is about an hour. Coz, I need to open the control panel, got a tester, and trsted all critical parts inside the panel.
Also, replaced the fuse just to make sure its a new one. Found out it was a switch (bottom part) that control the open/close of the microwave door.
When found out the problem, the rest of the work is easy.
Also, replaced the fuse just to make sure its a new one. Found out it was a switch (bottom part) that control the open/close of the microwave door.
When found out the problem, the rest of the work is easy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Christopher from CARY, NC
- Parts Used:
- 5304509435
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Cover needs replacing
You have to be very careful because the wave guide cover is very brittle. It needs to be bent very gently in order to fit the four ends into each slot. I would highly recommend buying two just in case the first one breaks.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- deanna from old town, ME
- Parts Used:
- 5304509435
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
replaced cover
I thought the cover was suppose to come off from the inside of microwave. It is brand new and got bent. So I ordered a new one in case it was not working with a bend in it.
Was this instruction helpful to you?
Thank you for voting!