AMC5143AAB14 Amana Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Richard from CALIFORNIA, KY
- Parts Used:
- WPM0805101
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
No power to any microwave functions
Access is via RT. SIDE Panel as you face microwave. There are three screws on the bottom right edge to loosen. After that the side panel slips down and off. the fuse is located in the rear near where the power cord comes in. It is the white ceramic tube 1/4" in dia. and 1-1/2" long. Pull it out like any fuse and replace with new one. Reassemble and you are done!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from MYRTLE BEACH, SC
- Parts Used:
- DE92-90189S
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Part broke
Got the part and replaced it. Simple. Pleasure to work with
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Pamela from Auburn, MA
- Parts Used:
- DE67-00087D
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Microwave door open/start button broken
pull out broken button
remove spring from broken button and place on back of new button
press new button with spring on back into
microwave
remove spring from broken button and place on back of new button
press new button with spring on back into
microwave
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Andrea from Rockwall, TX
- Parts Used:
- WP8183592
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers, Socket set
Dead Light bulb
Required that i remove the built in frame and mounting. Required tamper proof socket to remove housing. I removed the old bulb and simply replaced and reverse installed the cabinet.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jason from WASHINGTON, IN
- Parts Used:
- DE92-90189S
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Missing roller guide under glass plate
I used my pocket knife to open the package. I opened the door and removed the plate and set the guide down and put the glass plate back.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kenneth from Millsboro, DE
- Parts Used:
- WP8183592
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
Bulb out
"PIECE OF CAKE" Removed cover,removrd bulb, replaced bulb, replaced cover. "PIECE OF CAKE" P.S. Wife is happy.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Steven from Redmond, WA
- Parts Used:
- WP8183592
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Blown light bulb
You have to remove the cover which in my case was a little more difficult because the unit is wall mounted and has a frame around it. That was the hard part. Once the mounting frame was removed, you can remove the cover and the light bulb is on the top right side of the unit. One screw removes it and the new one pops right in. Put the case back on reinstall it in the wall and voila...piece of cake.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bruce from Houston, TX
- Parts Used:
- DE67-00087F
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
One of the hinge tabs on the back of the button broke.
Carefully removed the old button, taking care not to lose the spring, and reinserted the new button. No tools required.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from Bishopville, MD
- Parts Used:
- WP8183592
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers, Socket set
replace light bulb and security latch
you will a security socket T20. this unit was installed over oven, remove trim cover,remove screws holding unit in place,I used a helper to get the unit out, once out you have to remove all the screws holding the cover on,on two of the corners they use a security hex screw so you need a special socket for that. remove the door latch switch,take your time or you will break tab holding switch in. ask me how I know.but super glued broke piece in place and plugged wire back in.the new latch may have a second pin but look at old one and plug wires in the same way.the light bulb does not screw out so I had to purchase the entire unit.total cost under a $100.00 to do repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Harlan from Logan, KS
- Parts Used:
- WPM0805101, WP8183592
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
burnrd out light
Removed cover and installed light
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JOE from CENTERREACH, NY
- Parts Used:
- DE47-20009A, WPM0805101
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
no power to unit after replacing fuse
went to you tube and found a segment compatible to my issue.called the web site and ordered the thermostat fuse and ceramic fuse in case i had the wrong one purchased at the locale H/Depot. The only issue was I did not know that there was 2 different thermo fuses,,one controls fan and the other a basic one. luckily the fan wasn't the one that was blown.The woman i spoke to was very helpful and my order was AT MY HOUSE in less then 24 hours.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Valerie from Rock Springs, WY
- Parts Used:
- DE74-00023A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Cooking tray shattered
My daughter was trying to run the microwave timer and ended up nuking the cooking tray, which shattered. First web place I found wanted 55$ for this tray and this site sold it for 19.99. It shipped super quickly. I am very pleased with this company!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- outstanding from Galena, MD
- Parts Used:
- WPR9800486
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Pliers, Screw drivers
microwave would not heat.
hardest part was taking the microwave down off of the wall to gain access to the diode. Thought if was the transformer but ended up being just a blown diode. remove and replace and bench test. that part took 15 minutes . moral of the story don't boil water under the side of the microwave that holds the electric components.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Jeanne from Terlton, OK
- Parts Used:
- WP8183592
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Nutdriver, Screw drivers
I didn't have a recessed drive or bit
We got a a carbon steel but and drilled out the stews and put in regular screws. We also had trouble getting the cover back on and ended putting 2 more screws on the left side which had none. The installation was the easiest part of the installation.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Muhammad from Jersey City, NJ
- Parts Used:
- WPR9800486
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
No Heating.
Information provided on the web site by Part Select, were helpful and encouraging to select and buy the part needed to repair the appliance. No doubt, a skilled person having background in the repair of appliances should attend such repair job.
Was this instruction helpful to you?
Thank you for voting!