AOR27DEW (P1132341N W) Amana Microwave - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Lana from Pineville, WV
- Parts Used:
- WP77001092
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Oven element burnt out and broke apart.
After ordering the element, found out it was the wrong element, I needed an 18.5 inch x 15.5 instead of the 15 1/4 x 15 1/2"...I slowly bent the element in shape to fit my oven. It works beautiful.
But for you guys, order the right one. Don't forget to measure your old elements spread from connection to connection. Install the new element and then test to be sure it works proper.
But for you guys, order the right one. Don't forget to measure your old elements spread from connection to connection. Install the new element and then test to be sure it works proper.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- robert from chatham, VA
- Parts Used:
- WP74011278
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
hard to get old one out
easy to put in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Raymond from BLOOMINGTON, MN
- Parts Used:
- 4396923
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Purchased home but stove had no broiler pan.
Purchased 2 piece broiler pan from this site
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- frances from Coffee Springs, AL
- Parts Used:
- WP77001092
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Element broken, oven would'nt heat
First I removed the two screws that hold the element in place. Then I pulled the element out about 3 inches and disconnected the two wires. Reconnected the new wires, put the screws back in and the oven WORKED!!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carl from RIVERSIDE, CA
- Parts Used:
- 8009
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
light bulb in water ice freezer door went bad
I didn't. Don't know how to get to light bulb to change it for this specific model
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Stephen from Cedar Rapids, IA
- Parts Used:
- WP77001092
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Heating element burned out...forcing me to replace it.
Our oven is a wall mounted oven so I could not reach the plugin. Therefore I shut the power off at our breaker box. I then removed the screws that held the old heating element to the oven. Removed the element, slipped connecting wires off of the old element. Next I slipped the connector wires onto the new element and replaced the screws. Turned the power back and and checked to see if oven worked. It did! As you can tell I am a novice at home repair but this worked perfectly!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- elizabeth glennon from rochester, MA
- Parts Used:
- WP77001092
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
oven element burnt out
The cost of new ovens and a having an electrician come out to fix was ridiculous.We looked online fro an alternative and found your part w/ picture (which helped) for only 41.00 w/ tax to fix! We recieved item within 4 days and we fixed it in about 15 min. Thank you so much for saving us tons of money and loads of headache!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Sara from Harwich Port, MA
- Parts Used:
- WP74011278
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
needed new oven light assembly/part #PS1864256
Removed old assembly, attached wires to new and inserted into space for same. Of course you must turn off the range circuit breaker. The part that took the most time was removing the old assembly. Once that was done, the rest took only a few minutes.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Eduardo from baltimore, MD
- Parts Used:
- C8936902
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
tray glass floor broke
Remove old tray, clean old caulk, and clean inside of microwave, Place new tray-glass floor and caulk with heat resistant silicone. Easy project.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Yafa (and David) from Bothell, WA
- Parts Used:
- 8009
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
Replacing the bulb in the freezer side
Removed the ice brucket,
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.
Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas.
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.
Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ted from lagrange, KY
- Parts Used:
- C8936902
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
broken tray-glass floor of microwave
very simple job. removed broken tray, inserted new tray and caulked around edges with a high heat resistant caulk.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Susan from Springfield, CO
- Parts Used:
- WP77001092
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Element burned up
On the Saturday before Christmas, during some baking, my heating element we out of my oven! Since I was cooking Christmas dinner at my house on Thursday, I freaked out. Fortunately, we got on the interenet, ordered a new element, paid for 2-3 day shipping, and received it on Wed. afternoon. My husband unscrewed the old element, and put the new one in about 5 minutes. Very easy job, and Christmas was a total success!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Anthony from Social Circle, GA
- Parts Used:
- WP77001092
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
bottom burner was burned in half
It was very easy,it took five minutes to replace it. I disconnected the two leeds from old burner and connected them to the new one.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Genevieve from EULESS, TX
- Parts Used:
- WP77001092
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Heating element in electric oven went out.
Repairmen all wanted a pretty penny to fix the problem, basically buying a new oven would have been cheaper. I ordered the heating element I needed. Once it arrived I took it out of the box and handed it and screw driver to my Son-in-law and as he stood there with a dumb founded look I told him “replace the old with the new one or I will never cook for you again”. Boy did he do the work in a flash, it was easy peasy. I didn’t even break a sweat. I hope this is helpful to your other customers.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Marlin from Lincoln, MO
- Parts Used:
- WP77001092
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver
The element gave out
I just had to take 4 screws out and pull it out and put the new one back in!!
Was this instruction helpful to you?
Thank you for voting!