Models > ACM1120AW-PACM1120AW0 > Instructions

ACM1120AW-PACM1120AW0 Amana Microwave - Instructions

Jump to:

All Instructions for the ACM1120AW-PACM1120AW0
46 - 54 of 54
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
Thais from La Grange, TX
Parts Used:
4392027
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers
Motor quit working but light and timer still worked.
Since others reported similar problems and it was just the fuse we tried that first. That wasn't the problem so we ordered the Door Interlock Switch Kit. Shipping was very fast! Our microwave had 3 switches. My husband asked how to know which one to switch. I read that one person just did process of elimination. Luckily ours worked on the first change out! So happy to have stumbled across this site and not have to buy a whole new microwave.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lois from Chicago, IL
Parts Used:
WPW10267856
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Broken microwave glass tray
I had purchased the wrong replacement tray from Amazon and could not find the right one on their website. Yours was exactly what I needed.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Lewis from Loveland, CO
Parts Used:
4392027
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers
motor would start by itself when door closed
remove 4 screws from top, front louvered panel snaps out. remove 1 screw from top of keypad, keypad pivot's forward and can be removed. There is a white mounting bracket inside left. Remove two screws, one top and one bottom, bracket lifts up and out. 3 sets wires are attached, mark them with masking tape, top, center, bottom and pull out plugs. They can only attach one way. Using a very small screw tip, lift plastic latch from switch, it rotates out and is removed from the pivot pin. reassemble in reverse order after switches are replaced
Was this instruction helpful to you?
Thank you for voting!
Customer:
outstanding from Galena, MD
Parts Used:
WPR9800486
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers
microwave would not heat.
hardest part was taking the microwave down off of the wall to gain access to the diode. Thought if was the transformer but ended up being just a blown diode. remove and replace and bench test. that part took 15 minutes . moral of the story don't boil water under the side of the microwave that holds the electric components.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Jeanne from Terlton, OK
Parts Used:
WP8183592
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Screw drivers
I didn't have a recessed drive or bit
We got a a carbon steel but and drilled out the stews and put in regular screws. We also had trouble getting the cover back on and ended putting 2 more screws on the left side which had none. The installation was the easiest part of the installation.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Mrs. Diane from New Orleans, LA
Parts Used:
WPW10267856
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
cracked glass tray
very easy just put the tray on the turntable. excellent delivery service arrived sooner then expected.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Keith from oakdale, PA
Parts Used:
W10859575
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
Microwave was running, but would not heat
I started by calling a reputable service company to diagnose my problem. The repair tech told me it was the magnetron and it was a "very difficult" repair that required two people because the over-the-range unit needed to be taken down. I asked for a detailed estimate. He quoted $550 including parts and labor. After he left, I researched the part costs on this site and realized his costs were very inflated. I purchased the magnetron for $220. It arrived at my door two days later. Installation was very easy. First, I unplugged the unit. Then, while my wife was making sure it did not fall off the wall bracket, I unscrewed the two mounting screws from the top of the cabinet. I lifted the unit down from the wall and set it on the kitchen counter. The shell needed removed from the microwave which involved about 20 screws. This provided access to the magnetron on top. The magnetron is secured by five screws and a plug. I unplugged it, unscrewed it, and removed the old part. Then, I installed the new magnetron, and tested the microwave to make sure this did the trick. It worked. I put the outer shell back on the microwave and cleaned the microwave. (This is a great opportunity to clean the areas you do not typically see!). I then remounted the unit and plugged it back in. Saved myself a bit of money so I took the family out to dinner and a movie to celebrate. Microwave was in working order for heating up left overs the next day! Thank you!!!
Was this instruction helpful to you?
Thank you for voting!
Customer:
Muhammad from Jersey City, NJ
Parts Used:
WPR9800486
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers
No Heating.
Information provided on the web site by Part Select, were helpful and encouraging to select and buy the part needed to repair the appliance. No doubt, a skilled person having background in the repair of appliances should attend such repair job.
Was this instruction helpful to you?
Thank you for voting!
Customer:
chap from edmond, OK
Parts Used:
WP8183507
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Approximately 5 seconds into heating something, the microwave went dead
It literally took me longer to unpackage the fuse than to install it. I removed the outer shell by unscrewing the five screws, lifted it off and set it aside. The old fuse was readily visible so I pulled it out and put the new one in its place. I set the shell back on and replaced the screws. I plugged it in and ran it for 30 seconds while still in the shop just to make sure that solved the problem and presto - it worked like a charm. A $20 part saved me from having to purchase a new microwave (sadly, I had to break the news to the wife).
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the ACM1120AW-PACM1120AW0
46 - 54 of 54