Models > DE6612

DE6612 Samsung Microwave Oven Combo

Jump to:

Find Part by Name

Keep searches simple, eg. "belt" or "pump".
Keep searches simple, eg. "belt" or "pump".
In Stock
Order now and your part arrives by May 7
In Stock
Order now and your part arrives by May 7
This manufacturer-approved screw is for refrigerators, including Kenmore refrigerator model. Avoid cross-threading refrigerator screw during installation.
In Stock
Order now and your part arrives by May 7
In Stock
Order now and your part arrives by May 7
In Stock
Order now and your part arrives by May 7
$24.00
Special Order
$6.51
In Stock
Order now and your part arrives by May 7
$33.20
Special Order
In Stock
Order now and your part arrives by May 7
In Stock
Order now and your part arrives by May 7
$31.05
In Stock
Order now and your part arrives by May 7
$62.61
In Stock
Order now and your part arrives by May 7

Questions and Answers

Be the first to ask our experts a question about this part!

Common Problems and Symptoms for DE6612

Viewing 1 of 1
Won’t turn on
Fixed by these parts
Fixing
How to fix it
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Customer:
RICHARD from OKLAHOMA CITY, OK
Parts Used:
DE31-10154D
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers
Turntable Quit
Snipped four corners off inspection panel,removed one phillips screw and two elect. Connections. Reverse process.
4 of 6 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Ray from GRANBURY, TX
Parts Used:
DE47-20030A
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Thermostat failed because rivet was loose on connector blade; caused overheated wiring.
Replaced the the thermostat located above the magnetron.
1 person found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Customer:
Vinh from Houston, TX
Parts Used:
DE47-20030A
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers
Power cuts in and out; runs for a few secs then powers off
Disconnected power and removed Microwave housing cover, observed burned end plastic connector of wire connecting to the thermostat (or thermal overload sensor); slightly wiggle one of the 2 wires to the thermostat would cause microwave power to cut out (when plugged in power). When powered on, I would try to run it but power cuts out aft er just a few seconds. Removed the 2 wires from the old thermostat, removed the 2 screws that fasten down the thermostat, replaced with new thermostat and reapplied the 2 screws; cut off burned part of wire and resolder to new wire connector; reconnect both wires to new thermostat and reinstall MW housing cover. MW works good as new again. Thank you PartSelect!
Was this instruction helpful to you?
Thank you for voting!