LMV1681SW LG Microwave Oven Combo - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- vic from Allen, TX
- Parts Used:
- 6600W1K001D, 6600W1K001C
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
When the MW door was opened a fan would start running. Close the door the fan would go off.
Removed the MW from the wall. Took the top screws off the air vent. Then removed the two screws holding on the display. I then moved the display to its side and it revealed the micro switches. I removed the plug in leads from the micro switch one at a time. I did this with all three micro switches only one at a time. I reinstalled everything and plugged it in. No more fans starting when the door is opened.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from SEVERN, MD
- Parts Used:
- 3501W1A019D
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
food does not get hot, carousel did not turn, all other indicators worked
Read the troubleshooting section on this site. Figured it was an interlock problem because the food was not getting hot (magentron not turning on) and the carousel was not turning. Did not think both the carousel motor and magnetron failed at same time, thus indicated an interlock problem. The interlock switches are actuated by the door latch. Replaced the assembly locker piece with all three switches (only a $20 dollar part) and microwave was fully operational again. Wife and kids think I am a hero.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from ORCHARD PARK, NY
- Parts Used:
- 6600W1K001D
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Door switch was burnt out
Removed outer cover
removed lower door switch
installed new switch
Wa La!
removed lower door switch
installed new switch
Wa La!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Tina from EL DORADO, KS
- Parts Used:
- 5230W1A011B
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- More than 2 hours
UNABLE TO INSTALL DUE TO DAMAGED IN SHIPPING
WORTHLESS...I EMAILED YOU ON 2/7/22 AFTER RECEIVING THE DAMAGED FILTER DUE TO NOT SHIPPING IN A HARD OR SOMETHING IN THE ENVELOPE TO PROTECT THE FILTER FROM BEING BENT.
I HAVE NOT HAD ANY RESPONSE FROM YOU FOR THE DAMAGED FILTER OR WHEN I CAN EXPECT ONE THAT I CAN USE.
UNSATISIFACTORY SERVICE!
I HAVE NOT HAD ANY RESPONSE FROM YOU FOR THE DAMAGED FILTER OR WHEN I CAN EXPECT ONE THAT I CAN USE.
UNSATISIFACTORY SERVICE!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from DEL CITY, OK
- Parts Used:
- ADC49436904
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Outer glass in the door dropped down.
Took the part above the door off. Four screws. Removed the old door. Put the new door on and replaced the part above the door.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from CHARLOTTESVLE, VA
- Parts Used:
- 5230W1A011B
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Replacing top vent filter
Followed owners manual instructions to the letter: removed two top screws, opened the unit door so I could slide out the old filter. We don’t cook much at all in the unit, mostly just heating coffee and reheating leftovers. BUT! The top grill was pretty greasy and needed hot soapy water to clean, including in the depths of the top area. The whole process, especially the company website for part ID and purchase, was slick!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Bill from TAMARAC, FL
- Parts Used:
- 3550W1A126D
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
did not include screw to secure it to celing of the microwave rempved
removed old cover put the new one in place found right size screw from my tool box, tightened it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from KENT, WA
- Parts Used:
- MEB41908101
- Difficulty Level:
- Very Difficult
- Total Repair Time:
- 30 - 60 mins
AFTER 3 WEEKS I'M STILL WAITING FOR THE REPLACEMENT HANDLE
WHEN ARE YOU FINALLY GOING TO GET AROUND TO SENDING MY PART? HOW CAN I REPAIR THE MICROWAVE WITHOUT THE $35 PART I PURCHASED FROM YOU? PLEASE SEND MY PART IMMEDIATELY BEFORE I PHONE BBB AND JD POWERS.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from PURCELLVILLE, VA
- Parts Used:
- 4370W1A006B
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
The new part was too thick for the worn out plastic ring which is obsolete.
Needed to raise the part to match the ring. I used peanut butter to hold plastic shim while replacing to hold it in place. Built in Oct. 2009.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dick from SANDY, UT
- Parts Used:
- 6600W1K001C
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Microwave fan would come on when door open. Timer and unit would not switch on.
I looked up my problem on the internet and found a very helpful video. Microwave on video was different brand but the internals and methods were very much the same. The video made it simple and easy to fix. Found the replacement switch on the LG parts site and ordered. Two different switch types. One with red switch, the other green. Part was $7.28. Saved a bundle in service costs. Here is the repair video.
https://www.youtube.com/watch?reload=9&v=_AglBJoHgDs
https://www.youtube.com/watch?reload=9&v=_AglBJoHgDs
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- John from SARASOTA, FL
- Parts Used:
- 3550W1A126D, 5893W3A002D, 4051W3A001A, 3550W1A126B
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
Used You Tube and things went smoothly
Removed burned pieces and reinstalled new.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from MCMINNVILLE, OR
- Parts Used:
- 3052W1A002A
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
Replace resin cover in microwave
Used fingers to pull damaged cover away from microwave interior body. Used fingers to snap replacement cover into open slots.
Cover snap right into special slots.
Cover snap right into special slots.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- David from BIDDEFORD, ME
- Parts Used:
- MEB41908101
- Difficulty Level:
- Very Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Broken handle
Pulled off band unscrewed old handle and screwed on new one replace band
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Walter J Baxter from Billings, MT
- Parts Used:
- MEB41908101
- Difficulty Level:
- Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
First problem was removing the vent cover. There were four screws that were not obvious that held the cover on. Reinstalling the cover also proved to be difficult due to alignment problems. Once that was done, the second problem was removing the door. There is a small, almost invisible, latch that h
At home on the kitchen counter.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from enoch, UT
- Parts Used:
- MKC42429705
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Screw drivers
Broken glass
Remove inner door panel with putty knife remove door handle door panel replace glass put back together very easy PS clean the glass when you're done optional LOL
Was this instruction helpful to you?
Thank you for voting!