13AM761F065 (2009) Bolens Lawn Tractor - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Laurie from RICHLANDS, NC
- Parts Used:
- 731-05628
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Socket set, Wrench (Adjustable), Wrench set
Oil Drain Sleeve
I wish this was longer...it's only about 6", barely enough to have the oil flow past the metal plate of the riding lawnmower. I'm going to figure out a way to make a permanent extension something like this video would be SO much better https://www.youtube.com/watch?v=G9ZVoeqr6R8&t=79s
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- michael from eden, NC
- Parts Used:
- 731-04949A
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
Didn't line up very easy
Put one side in bottom first and you have to slightly twist the lens to get the other clips to pop in.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- LISA M from BATESVILLE, AR
- Parts Used:
- 737-0300A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Mixer began to make a noise on speed two and higher
We took our 30 plus year mixer apart. I removed the old grease. There was some crumbly looking grease in the main housing gear section where the nylon gear is located. It looked like it had flour mixed in it. Not certain. Removed as best possible all old grease and applied 6 oz. of new Benalene grease to all of the gears. Now it does not make the slight howl sound.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- GINO from MURRAY, KY
- Parts Used:
- 783-04602C-0637
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers, Wrench (Adjustable)
light switch broken
Had to pull stove out of the way for easier replacement of the hood switch. Exact replacement part was simple to change.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from BAY VILLAGE, OH
- Parts Used:
- 747-04332A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Bent the old one on a stump
Removed one 1/2" bolt to remove old part .
Slipped new part in place. put bolt in open loop and tightened.
Slipped new part in place. put bolt in open loop and tightened.
Was this instruction helpful to you?
Thank you for voting!