20656 (260000001-260999999 - 2006) Toro Lawn Mower - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Mower body was die cast and in good condition. Engine was burning oil.
Removed engine, no specialty tools required. Honed the cylinder, and lapped the valves. Tip on compressing valve spring for reassembly; compress springs with you finger and tie them with 2 zip ties, cut the zip ties after installing the keepers. Repainted the mower deck and engine. It runs and looks like new. My Toro is a 1999 model .
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Dustin from BANGOR, ME
- Parts Used:
- 590508
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- More than 2 hours
- Tools:
- Socket set, Wrench set
Leaking gaskets
All the gaskets needed to be replaced on the Briggs 6.75 flathead I was rebuilding. I ported and polished the ports and shaved the eyebrow between the valves and the piston. The gasket set was a perfect fit. It is a monster now. It doesn't sound like a lawnmower engine anymore
Was this instruction helpful to you?
Thank you for voting!
The hub that the mower blade mounts to was broken
The hub that the mower blade mounts to was brokenPut the new Harbonne played and played securing flange bolted it up
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Henry from ORLAND PARK, IL
- Parts Used:
- 121-9118
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Torsion spring broken
I pryed the apart the torsion spring lever from the handle with a large screw driver. It wasn't easy putting it back, but it worked
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ray from YARDLEY, PA
- Parts Used:
- 105-1809
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set, Wrench set
Wheel height adjuster lever (spring steel) cracked / split in two.
Tip mower onto side, raising side to be repaired. Empty gas tank if possible or use rags to prevent gasoline drips onto clean surfaces.
Remove wheel using a 1/2" socket.
Remove wheel height assembly with 1/2" socket and open end wrench to hold nut below the deck.
Position new spring arm over the slot on wheel height assembly plate. Check opposite side to verify correct orientation if needed.
Remove plastic cover from old lever using a small flat blade screwdriver. Slip onto new lever.
Replace wheel height assembly.
Replace wheel.
Remove wheel using a 1/2" socket.
Remove wheel height assembly with 1/2" socket and open end wrench to hold nut below the deck.
Position new spring arm over the slot on wheel height assembly plate. Check opposite side to verify correct orientation if needed.
Remove plastic cover from old lever using a small flat blade screwdriver. Slip onto new lever.
Replace wheel height assembly.
Replace wheel.
Was this instruction helpful to you?
Thank you for voting!