917374422 Craftsman Lawn Mower - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Russ from ALTENBURG, MO
- Parts Used:
- 532401274
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
My self-propelled lawnmower did not function. The front wheel assist did not work.
I removed one of the wheels and noticed that the gear teeth were worn off. I then checked the other wheel and it was the same. I ordered two replacement wheels and replaced the worn wheels with the new wheels. It took less than 15 minutes to remove the old wheels and replace with the new wheels. It took a ratchet and a 9/16 inch socket. It was a very easy repair.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- James from ASHTABULA, OH
- Parts Used:
- 532183567
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers
Cable was broke.
Pushed the cable through the engine mount.Connected the cable to the engine slider. Pulled cable through the previous tie down connected to the lower end of the bar. Attached the connector on the cable to the hole in the lawn mower bar near the top of the bar.. Attached the top end of the cable to the on/off bar where you push the mower.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Walter from EVERETT, WA
- Parts Used:
- 581840401
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Front drive wheel locked up, causing the mower to not be able to be pushed.
Removed wheel by pressing off the plastic hub cap exposing the nut holding the wheel. I removed the nut, then pulled the wheel straight off the axel shaft. This exposed the broken dust cover. I they wiggled the dust cover off, cleaned the dirt from inside the wheel, placed the new dust cover, replaced the wheel, nut and hub cap.
Was this instruction helpful to you?
Thank you for voting!