3709 Makita Laminate Trimmer - Parts

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing y...

This part includes two carbon brushes with wire leads and brush springs. Worn brushes are typically presented as a failed or underperforming motor. Carbon brushes are a part that commonly wears, so it...

This is a M4 X 10 countersunk screw, and it is sold individually. This screw is compatible with various models, so its location may differ depending on your equipment. To fasten and unfasten this scre...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwis...

This item is a genuine Makita part that has been sourced from the original manufacturer to be used with trimmers, circular saws, sanders, routers, nailers, reciprocating saws, laminate trimmers, and p...

This replacement adjustment knob/screw is a genuine Makita part. It is supplied from original equipment manufacturer for use with belt sanders/trimmers. While the belt is running, use the adjusting kn...

This brush cap is a genuine OEM sourced replacement part. It is commonly used on a variety of Makita power tools. This brush cap helps to secure the carbon brush in the brush holder. This cap has exte...

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter...

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ...

This tapping screw is an authentic hardware that is supplied by original tool manufacturer for use with a variety of Makita power tools. It has multiple uses depending on the model of your unit, pleas...

This part is available as an individual replacement. The base attaches to the motor housing. A screwdriver and a wrench might be helpful during the installation of this part. It is made out of plastic...

This genuine manufacturer-sourced part is specially designed for use with Makita power tools. It is an identical replacement for a missing or a faulty nut that was installed on a new unit. This is a s...