Models > KUIC15PHZS0 > Instructions

KUIC15PHZS0 KitchenAid Ice Maker - Instructions

Jump to:

All Instructions for the KUIC15PHZS0

Customer:: Michael from Clanton, AL
Parts Used:: WPW10217918
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

Inlet water valve restricted with debree.

Open appliance door. Removed access plate at lower front (two screws). Removed two screws holding valve in place. Depressed water line retainers and removed water lines from valve. Inserted water lines in replacement valve, remounted valve, reinstalled access plate. Tested operation. (I did install a water filter during the repair to prevent reoccurrence.)

Was this instruction helpful to you?

Customer:: Marshall from Garland, TX
Parts Used:: W10124096
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Screw drivers, Socket set

Condenser Fan Motor had stopped working

I found the part I needed on this website, watched the tutorial and saw how simple it was to do myself. I ordered the part and it arrived within a few short days. It took me no more than 15 minutes to change out the part. I saved myself several hundred dollars. It is rather shocking how much the "professionals" charge considering the cost of parts, labor and nominal service fees.

Was this instruction helpful to you?

Customer:: kevin from Antelope, CA
Parts Used:: W10124096
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Pliers, Socket set

refrigerator not cold. and keeps striping the circuit breaker and shutting off other appliances using the same circuit.

what I discovered is the condenser fan is still operating but not strong another word insufficient cooling for the condenser. therefore, it's getting too hot and shutting off and stripped the circuit breaker. After installing the new condenser fan, it gets back in business. it's quite simple. Just unplug the unit off, uncover the bottom back cover and there you see compressor, condenser fan and other good stuff. there you unscrew the nut in front of the condenser fan and remove the fan, then it expose the two screws that holding the fan motor, remove these screws and take out the motor. and just install the new fan motor kit in and there you have it. plug it back to the wall and there it goes

Was this instruction helpful to you?

Customer:: manuel from wilmington, DE
Parts Used:: W10124096
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Screw drivers

Very noisy when condensor fan came on

I've tried ordering the part from Sears and they told me it will take about 7 days for the part to arrive, some other place said it will overnite for extra money. So I've ordered the part from Part Select at a good price and prompt delivery. once the part arrive installing the part so so easy cause it had easy to follow instructions.

Was this instruction helpful to you?

Customer:: Diane from Rocky Mount, NC
Parts Used:: W10124096
Difficulty Level:: A Bit Difficult
Total Repair Time:: 30 - 60 mins
Tools:: Screw drivers, Socket set

fridge started making an awful noise...still worked but noise occurred when fan kicked on

My husband watched the video on the repair and followed it step by step...works like a charm! The repair shop wanted 299.55 to fix it - the part was 79.00....big savings by doing it ourselves.

Was this instruction helpful to you?

Customer:: Edgar from Kokomo, IN
Parts Used:: W11291138
Difficulty Level:: Easy
Total Repair Time:: Less than 15 mins
Tools:: Screw drivers

switch that turns light on in refridge broke

watched the video how to remove, and did it.

Was this instruction helpful to you?

Customer:: Joanne from Bourbonnais, IL
Parts Used:: W11291138
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Pliers

Light switch broke

Pulled out old switch with needle nose pliers, unplugged old switch and plugged in the new one and snapped back into place. Very easy to repair. Took less than 10 minutes

Was this instruction helpful to you?

Customer:: Craig from Tomah, WI
Parts Used:: W10124096
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Pliers, Screw drivers

Noisy/Failing Condenser Fan

Unplugged the refridgerator and pulled the rear cover. Had to take the fan blade off in order to get at the screws holding the existing motor in place. Removed the old fan. Pressing the new plastic fan onto the new motor shaft was a little more effort than expected, but I guess it won't come off. I have large hands so mounting the new unit was a little bit of a challenge getting the small screws started. Once the three screws were tightened all I had to do is plug the electrical connector in and replace the rear cover. I was happy that the existing electrical connector was the right one for the new motor too, and that I didn't have to use the provided wire harness. All in all the repair went pretty well.

Was this instruction helpful to you?

Customer:: William from Fort Mohave, AZ
Parts Used:: W10124096
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

loud noise coming from back of fridg.

Unplug A C Cord . Simply unscrewed lower back cardboard cover panel and unscrewed condenser fan motor , removed wiring plug , pulled fan motor out removed fan blade and put it on new motor . then I Reinstalled motor. Noise is gone . EASY INSTALLATION .

Was this instruction helpful to you?

Customer:: Andrew from Albuquerque, NM
Parts Used:: W10124096
Difficulty Level:: Really Easy
Total Repair Time:: Less than 15 mins
Tools:: Nutdriver

condenser fan motor worn out and making noise.

Instructions were really clear and easy to follow. Hardest part of the job was moving the refrigerator away from wall after it was filled with holiday groceries.

Was this instruction helpful to you?

Customer:: william from glen gardner, NJ
Parts Used:: W10124096
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Socket set, Wrench set

Unit very noisy when running sometimes and then get quiet the noise would vary

Remove back panel on unit locate condenser fan and motor remove three small screws holding motor assembly to metal bracket disconnect electrical connection press new fan blade on new motor reverse directions

Was this instruction helpful to you?

Customer:: Ordean from Minot, ND
Parts Used:: W10124096
Difficulty Level:: Really Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Socket set

No problem

The repair went just fine. Your instruction regarding using the wiring harness were clear. Most of all I am happy to not have to listen to a noisy motor all night.

Was this instruction helpful to you?

Customer:: Robert from Perrysburg, OH
Parts Used:: W10124096
Difficulty Level:: Really Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver, Pliers, Socket set

Condenser fan made loud noise.

Watched the video that was attached to my order confirmation (great idea) and just followed it step by step. Real easy repair since I had tried to fix the noise first without ordering parts, so I knew what I was doing Did a temporary fix which quieted it down while I waited for the parts and then the repair itself was pretty straight forward.

Was this instruction helpful to you?

Customer:: Jennifer from San Antonio, TX
Parts Used:: W10124096
Difficulty Level:: Easy
Total Repair Time:: 30 - 60 mins
Tools:: Nutdriver, Screw drivers, Socket set

Condenser Fan quite

I tried WD40, it worked for a day. Got a new part from PartSelect.com and was a good brand. Panasonic. Easy fix and works great. Saved a bundle. I priced a new fridge, no way, this was better. Thank you Partselect.

Was this instruction helpful to you?

Customer:: Brian from Saint Augustine, FL
Parts Used:: W10124096
Difficulty Level:: Easy
Total Repair Time:: 15 - 30 mins
Tools:: Nutdriver

Loud fan motor

Removed lower plate on back of refridgerator and changed out fan. The video was great and made the repair a snap. Fan is quiet and no more overheating refridgerator.

Was this instruction helpful to you?

All Instructions for the KUIC15PHZS0