HR2470FT (Type 1) Makita Hammer - Parts

Genuine Makita replacement part. Set of 2 Carbon Brushes with wire lead attached. • Worn brushes are often the cause of a poorly running motor • Replacing brushes can fix an intermittent motor ...

This is a power cord, and it is used with several power tools. It is made of a thick rubber that is tough, and insulated for a long life. It has two 18 gauge wires, and is 8 feet long. When removing y...

Included in Part Number 516306-1. rnThis Ball Bearing is sealed on both sides. This genuine Makita replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating par...

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or r...

This genuine manufacturer approved hammer grease is sold individually. This petroleum based grease is designed for use with Makita hammers. It helps to lubricate the system allowing for easy movement ...

This authentic replacement part which is specially designed for use with Makita power tools. Ball bearings are used to reduce friction between rotating parts, over time components may begin to wear ou...

This steel ball is an authentic OEM component which is specially designed for use with Makita rotary hammers. The ball is fitted within the tool holder, providing the ability to secure a drill bit. It...

This hex nut is sourced directly from an original manufacturer. It is an authentic hardware designed for use with Makita power tools. This is standard hardware which has multiple applications based on...

This replacement flat washer is a genuine OEM part, not an aftermarket equivalent. It is specially manufactured for use with Makita power tools. This standard hardware has multiple applications depend...

This cord protector is an OEM part designed for a variety of Makita power tools. It is attached where the power cord meets the tool. This part protects the cord from damage due to pulling, bending, or...

This part is priced individually. The rubber cap fits on the nose of the device next to the ring spring and the chuck cover. A screwdriver may be needed to replace this part if it becomes broken. This...