GA5042C Makita Grinder - Parts

Set of 2 Carbon Brushes with wire leads and brush springs attached. The set contains genuine Makita replacement parts, and comes packaged in a Makita retail box. rnThis brush set will fit the Makita t...

This power cord is for power tools. Unplug the power tool before installing this part. Wear work gloves to protect your hands.

Genuine Makita replacement part, this item is sold individually. The purpose of this Clamp Nut is to secure the Grinding wheel to the spindle of the Grinders shown below. To tighten the nut to the spi...

This is an Original replacement part used on certain Makita Angle Grinders. This part is made out of Metal and it is Sold Individually. The purpose of this Flange is to hold the Grinding Wheel to the Spindle Shaft.

This Ball Bearing is sealed on both sides. This is a genuine Makita replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or r...

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. There are man...

This manufacturer sourced replacement pin is made out rubber and it is sold individually. It acts as a cushion/spacer in a variety of Makita power tools. This is a standard piece of hardware and it ha...

it is an authentic high quality Makita replacement part that is specially manufactured for use with sanders and grinders. This is the insulation washer for the armature, please make sure to check appr...

This is an authentic replacement part sourced from original equipment manufacturer. It is generally used on Makita angle grinders and sanders. This wrench allows you to secure a cutter blade/grinding ...

This part is available as an individual replacement part. The magnet sleeve goes between the stop ring and the wave washer. It is made of plastic and will require replacing if it becomes broken. A scr...

This is an authentic replacement part manufactured for Makita products. This metal washer has many applications usually used as a spacer for bearings. This washer is sold individually, please see mode...