25328712804 Kenmore Freezer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Kenneth from Tahlequah, OK
- Parts Used:
- 216486500
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
stop-basket was broken
I stuck the new stop-basket in the hole where it belonged.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Mike from Satellite Beach, FL
- Parts Used:
- 297309000
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Fan would not start occasionally
I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rebecca from Ventura, CA
- Parts Used:
- 297350101
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
The door to soft freeze was broken off
Very easily. Just had to remove the door bin/shelf unit by lifting it up and out. Then set in the new one. Took longer to empty and replace the items in the bin and on the shelf. This was a no brainer. What was important was how helpful the gentleman who found the item to order, when it wasn't easily found. I do not think this is worth posting, but I did want to complement the the man who took the order.
Was this instruction helpful to you?
Thank you for voting!