25314502101 Kenmore Freezer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Dennis from COLORADO SPGS, CO
- Parts Used:
- 297313200
- Difficulty Level:
- Very Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Socket set
Broke freezer lid hinge.
Simple fix, the new hinge fit like a glove simple R&R.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Edward from Philadelphia, PA
- Parts Used:
- 216848200
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
wanted a third basket for the freezer
No repair. Just placed the basket in the freezer.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Reynold from Belen, NM
- Parts Used:
- 5304496559
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
Thermostat would not hold the temperature
I replaced the thermostat. (Note: On a chest freezer, there is a copper tube going up into the wall of the freezer. The capillary of the thermostat goes into this tube.) 1. Unplug freezer. 2. Remove temperature knob. 3. Remove screws and remove cover plate. 4. Unclip old thermostat. 5. Using pliers, gently pull down the rubber seal on the capillary where it enters the copper tube. 6. Pull capillary out of copper tube. (In my case, the capillary was not free to pull out. I had to grasp the capillary with pliers and tug hard.) 7. Place rubber seal over the new capillary. 8. Insert the new capillary into the copper tube and put the rubber seal over the end of the copper tube. 9. Install thermostat body in the cover plate using the clip on the thermostat body. 10. Replace cover plate and temperature knob.
Was this instruction helpful to you?
Thank you for voting!