FCM7WMNBWW General Electric Freezer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- H.K. from Seagoville, TX
- Parts Used:
- WR55X24065
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
compressor not starting
Refrigerator is not cooling. Light and fan working. Changed the capacitor.. Still not cooling. Back to discovery mode.It may be the timer
Certainly not PartSelect's fault. They have great service.
Certainly not PartSelect's fault. They have great service.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- scott from Painesville, OH
- Parts Used:
- WR09X10089
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Pliers, Screw drivers
Freezer ran constantly
removed 2 phillips screws for side panel and one for cold control faceplate. Pulled control away from chassis, disconnected wires with pliers, pulled out long sensor wire going into freezer. Installed new part in reverse order. Works like a charm, should save energy and money.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- christopher from yonkers, NY
- Parts Used:
- WR09X10089, WR05X10009
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
freezer was warm - compressor didn't come on
tilted freezer up and removed side door , replaced cold control , and reinstalled side door , plugged freezer in and freezer is working fine now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kevin from Morris, IL
- Parts Used:
- WR55X24065
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver
Compressor not coming on
Had to e-mail GE for electrical schematic. Checked voltages to compressor. Jumpered compressor to see if it would even come on. Found bad run capacitor. Fixed.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Country at from SAYRE, OK
- Parts Used:
- WR55X24065
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Nutdriver, Pliers, Screw drivers
A power surge made my side by side refrigerator stop working
I started at the compressor and replaced the overload and the Ptcr first and that did not make the compressor start running again, so I replaced the capasitor and it still did not start, so I bit the bulett and replaced the Main Control Board and that is what I should have checked first, when I removed the old one I found a little burnt spot on the back that I could not see from the front. The new one did not look exactly like the old one, it had two more wire terminals than the old one, but just leave them blank and everything will work just fine!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Normand from Warren, MI
- Parts Used:
- WR13X10264, WR13X10263, WR02X11341
- Difficulty Level:
- Easy
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
Needed to create a 10" Keezer collar for chest freezer.
Cut 1'x10'x10" select pine board into 4 pieces. Attached the four pieces using the Kreg Jig Jr to each other. Stained and polyurethane for appearance. Added EDM weather strip to bottom edge of collar. Disconnected hinges and removed lid from freezer chest. Placed collar on top of chest freezer then placed lid on top of collar. Carefully aligned collar to freezer and lid to collar. Attached existing hinge of lid to collar, then mounted new hinges to existing freezer mount location then attached new hinges to collar. Double hinged collar. Nice!!!! Not a repair but an improvement.
Was this instruction helpful to you?
Thank you for voting!