FCM7DNAWH General Electric Freezer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- JOSE from NEW YORK, NY
- Parts Used:
- WR55X24064
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
fan and compressor wont start
Googled the model number of refrigerator with symptoms of "refrigerator wont run". Parts select web site appeared on my screen, opened Parts Select website, Partselect said probable cause of my frige symptom was that the run capacitor usually burns out 51% of the time. They were correct with the diagnosis 100%. I ordered the run capacitor for $23.00, installed it in 10 minutes, refrigerator runs good as new. Thank you for saving me cost of service call. I probably saved $200 or more. I will use Partselect again with my next problem. THANK YOU,
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Paul from Irving, TX
- Parts Used:
- WR07X26748
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
all power to refrigerator quit
layed fridge face first on a chair removed cover with flat head screwdriver unplugged part replaced with new part replaced cover returned to upright and plugged in
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- christopher from yonkers, NY
- Parts Used:
- WR09X10089, WR05X10009
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
freezer was warm - compressor didn't come on
tilted freezer up and removed side door , replaced cold control , and reinstalled side door , plugged freezer in and freezer is working fine now.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Normand from Warren, MI
- Parts Used:
- WR13X10264, WR13X10263, WR02X11341
- Difficulty Level:
- Easy
- Total Repair Time:
- More than 2 hours
- Tools:
- Screw drivers
Needed to create a 10" Keezer collar for chest freezer.
Cut 1'x10'x10" select pine board into 4 pieces. Attached the four pieces using the Kreg Jig Jr to each other. Stained and polyurethane for appearance. Added EDM weather strip to bottom edge of collar. Disconnected hinges and removed lid from freezer chest. Placed collar on top of chest freezer then placed lid on top of collar. Carefully aligned collar to freezer and lid to collar. Attached existing hinge of lid to collar, then mounted new hinges to existing freezer mount location then attached new hinges to collar. Double hinged collar. Nice!!!! Not a repair but an improvement.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Charles from Durham, CA
- Parts Used:
- WR55X24064
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
compressor running and hot, refer and fridge room temp.
Watched a youtube on capacitors- though on a motor with a pulley, the symptoms were the same, motor running and pulley not turning-bad capacitor. Took a chance for a 17+ dollar part vs a new compressor. It worked.
Was this instruction helpful to you?
Thank you for voting!