GLFH17F8HWE Frigidaire Freezer - Instructions

Replace thermostat and show and tell made it easy.

I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.

slipped in the new bins very easy

I stuck the new stop-basket in the hole where it belonged.

The electronic control did not defrost the coils. I had to use a screw driver to pry the unit off of the door. The instructions on line said use a putty knife or butter knife. I bent both trying to remove it. I suggest using a heavy duty screw driver. Once the unit was removed it was simple to put the new one back. It just snapped back in place. I also replaced the thermostat just in case. It's like buying $11.50 insurance. That required removing several screws and unsnapping the thermostat and unplugging the wires. Then putting the new thermostat back and plugging in the wires. Very easy to change the thermostat.

Unplug freezer let stand all night to defrost. Remove the tray cover which is located on the upper back area inside the freezer.( 3 twist fittings remove it ). Remove the upper stainless steel panel which is secured with 6 screws. This will drop down exposing the condenser. Note all the wires and fan will stay attached to the stainless steel panel, this panel will drop down no need to unplug anything. On the left upper side next to the condenser you will see the thermostat. Two color coded wires. Remove the thermostat and install the new one at the same location.

Very easily. Just had to remove the door bin/shelf unit by lifting it up and out. Then set in the new one. Took longer to empty and replace the items in the bin and on the shelf. This was a no brainer. What was important was how helpful the gentleman who found the item to order, when it wasn't easily found. I do not think this is worth posting, but I did want to complement the the man who took the order.

inserted key and turned

I order a new controll unit and it arrived the next day. Installed the new unit and we were back working. Great service. Thank you very much

The sliding shelf side rail is held by three philips head screws that tighten into nut inserts. No amount of tightening would keep two of the three screws tight. I found that the nut inserts which are plastic and insert into the side of the freezer would pull loose, probably from years of overloading the sliding shelf basket. Ordered two nut inserts from PartSelect. 1. Remove three screws to remove shelf slide side rail. 2. Remove nut inserts to be replaced with needle nose pliers or reinsert screw a couple of turns and pull nut insert out with pliers. 3. Insert new nut inserts, position side rail, and tighten screws. Replace sliding shelf/basket.

Ordered freezer key friday afternoon received it saturday afternoon. Fast service