FRS20WRHW2 (V2) Frigidaire Freezer - Instructions

The service man that I hired to fix my Ice maker removed the broken one. This is how I saw how easy it was to install. When the new one arrived all I had to do was plug it in then tighten 2 screws with the right size nut driver. This was the hardest part of the install havng the right tool for the job. Now I have Ice!

Traced issue to defrost timer ( burned compressor & element contacts). This unit is mounted next to the temperature adjustment control in the refridgerator area - right in front. Removal of plastic cover provided easy access to the timer. Unit unscrews from the mounting then unplugs. Installation is reverse of removal.

I simply removed 4 screws holding the casing and then 2 more holding the timer. It was very easy. I then replaced the timer by unplugging and plugged the new one in. I replaced all the screws and the job was done. Less than 30 minutes. I was very impressed with the shipping time. When I ordered the part, I had it the next day.

It was just a simple replacement, three nuts to loosen , a slight adjustment on the timer and reversal installation...As simple as replacing a light bulb! You needn't be a brain surgeon to do this job! Your installation video was very helpful....Thank you PartSelect Chuck McCann

The repair took only 5 minutes. I removed the ice bin, which just slides out, then loosened 2 screws at the back-top of the ice maker. I then unplugged the broken ice maker, removed it, put in the new one, re-tightened the screws and plugged it in. It was making ice within an hour.

Removed old tray by hand, replace with new tray by hand. This web site was BY FAR the easiest to navigate to find the right part. Shipping was extremely fast, received the part the very next day without special shipping. THANKS for the "EASY" button.

first, disconnected the power, turned off the water, marked the supply hoses 1 for water 1 for ice, removed the hoses and the supply water hose, and the wires, remove 2 holding screws from the valve, attached the new dual valve only needed 1 screw (due to the improved design) attached the wiring, and the marked hoses. and supply line to the new valve. put the frig back in place reset the ice maker. The next morning the ice bin was 1/2 way full. This unit is 15 years old and works like brand new now.

Ordered a new defroster timer and replace old one. It works just fine. A $35 repair vs a $500 new appliance.
Cool.
GWE

Turned off water, unplugged refrigerator, Removed defective unit with support bracket. Installed support bracket, adjusted flow screw per instructions, plugged in wiring with adapter, hung on screws, tighened screws, secured excess wiring harness (making sure it did not hang below icemaker per instuctions), turned on water, plugged in refrigerator. Comment it took a few hours to start making ice, air in line? After a couple of days seems to be working fine.

Loosened 2 screws, lifted icemaker brackets off of loosened retaining screws, unplugged electrical connector from the icemaker.
plugged in the supplied jumper harness & connected to the new icemaker, hung it on the loosened screws, secured the 2 screws.
Dranke beer & listened to my new icemaker rock & roll.
No further problems, Frigie like new.
The price was the cheapest I could find. $78.00 total including shipping.
A little girl could replace this unit.

removed drawer, removed front, slid in the front, put back in. done

Discarded/recycled old part and snapped in the new. Done.

replaced it

I removed the ice bucket from the freezer, took the front off with a screw driver, and then put the front on the new bucket and replaced it in the freezer. It was very easy.

ordered part. received part with one lead missing. reordered part. replaced bad part when a good one arrived.