CH11S-16119 Kohler Engine - Parts

This is an authentic OEM component from Kohler. The metal screw is made for use with many lawn and garden engines. Sold individually, this item often helps to secure the closure plate. A wrench is req...

This is an authentic, Kohler replacement part. The metal, choke linkage is compatible with many small, lawn and garden engines. The part is secured to the choke mechanism, and is responsible for helpi...

This is a genuine replacement part sourced directly from the manufacturer. The heat deflector is commonly found in Kohler engines. This part is made of heat resistant plastic, and is placed to prote...

This is a genuine manufacturer-supplied part that is made for use with Kohler engines that are commonly installed on a variety of lawn and garden equipment. The gasket provides a tight seal for the bo...

This is an OEM part sourced directly from the manufacturer. The connector is commonly found in Kohler engines. This part is made of high-quality plastic, and is attached to the rectifier regulator t...

It is a genuine item that is supplied by the original manufacturer for use with Kohler engines that are commonly installed on lawn and garden equipment. This is a special tube that the air travels thr...

This is an OEM part sourced directly from the manufacturer, and used in small, outdoor engines. The collector plate gasket is made of a cardboard material. This item is used to help block fuel droplet...

This is sold as a set of two. The key is made out of metal. No tools will be necessary to replace this item. It may become broken or lost and will need to be replaced. This is an authentic OEM sourced...

This genuine item is supplied by the original equipment manufacturer for use with Kohler and Toro engines. The thread forming screw attaches to the fuel tank bracket. It may require a wrench during in...

This is an authentic replacement part manufactured for use with engines from Kohler and Toro. Unfortunately, over time it may wear out and eventually require a replacement. The user will need to repla...

The throttle shaft is made out of metal. This part is available individually. It is an OEM from Kohler for use in engines. When replacing this part a screwdriver, a socket set, and a wrench set might ...