WED8500DC1 Whirlpool Dryer - Parts

This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers,...

Sold individually.

Metallic screw that is less than an inch long. Does not include the plastic washer.

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over ...

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

This authentic OEM high limit thermostat is made for your dryer. It is an important dyer element, because it will automatically shut off the heating element when it overheats. Be sure to disconnect th...

This is the replacement lint screen for your dryer. It is made of plastic and is approximately 14 inches by 9 inches. The lint screen traps unwanted lint and debris so your dryer can effectively dry y...

This shaft is for the front with right hand thread. Sold individually.

This part is located on the drum roller support shaft.

This part seals between the blower housing and the blower housing cover.

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately