WED9600TA2 Whirlpool Dryer - Parts

Metallic screw that is less than an inch long. Does not include the plastic washer.

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumbl...

This door hinge is used to hold your door on your dryer in place. Most dryers require two and they are sold individually.

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

This shaft is for the front with right hand thread. Sold individually.

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

This hose can handle hot or cold water and is five feet long.

This part seals between the blower housing and the blower housing cover.

This part is located on the drum roller support shaft.