WED9400SW1 Whirlpool Dryer - Parts

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one time use fuse, so when it does trip, you must replace it. The hi-limit thermosta...

This thermostat helps keep your dryer safe by turning off the heat if things get too hot. If your dryer’s overheating or not working right, this part might be the fix. It’s made to fit your model and ...

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumbl...

This door hinge is used to hold your door on your dryer in place. Most dryers require two and they are sold individually.

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

This shaft is for the front with right hand thread. Sold individually.

This part seals between the blower housing and the blower housing cover.

This part is located on the drum roller support shaft.

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately