GEW9200LW1 Whirlpool Dryer - Parts

Metallic screw that is less than an inch long. Does not include the plastic washer.

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over ...

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Sold Individually.

Sold individually. This knob accepts a D-shaped shaft.

This knob is used to control settings on a washer.

This kit comes with 2 adhesive pads, 2 brackets and 4 screws. This is for stacking the appliances vertically - dryer over washer.

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumbl...

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

This shaft is for the front with right hand thread. Sold individually.