DBLR453GT0AA Whirlpool Dryer - Parts

This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both h...

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

This part is used to start the dryer once you have selected a setting on the timer.

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

This lint filter helps capture lint and fibers during drying to keep your GE dryer working properly. It fits easily into the lint housing and helps prevent clogs and airflow issues. A simple replaceme...

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

The adjustable leveling screws on the bottom of your dryer can be screwed in or out to lower or raise the leg level. If one of the leveling screws is stripped, damaged, or missing, you may not be able...

This front dryer drum bearing does not come with slides.

Almond in color.

If your dryer is making a squeaking noise this seal may need to be replaced.

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on, a new motor pulley must be ordered.