DBLR453GT1AA Whirlpool Dryer - Parts

This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both h...

This is a genuine OEM replacement timer knob for your dryer. It is made of white plastic, and includes the metal clip that fits onto a D-shaped shaft. Replacing this part is an easy repair, simply pul...

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

This part is used to start the dryer once you have selected a setting on the timer.

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

This part helps to keep the door closed while the machine is running.

TThe door strike for your dryer is mounted on the dryer frame that the door shuts onto. It fits into the door catch on the door and keeps the door closed. If the door strike is damaged or missing, the...

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

This part is the replacement main valve coil for your dryer. It is black and white in color and has 2 terminals. It is approximately 1 inch long and 1 inch wide. The main valve coil opens the gas valv...

NOTE: Be very careful to not handle the igniter by its gray part as it's very fragile. Hold it by its white tip only.

This front dryer drum bearing does not come with slides.