WGD5050LW1 Whirlpool Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Victoria from Sewell, NJ
- Parts Used:
- 8212450A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
I just needed to replace the rack in my dryer
This did not require a "repair", just a replacement. I want to say that the response time and ease of ordering were very good. I would not hesitate to use PartSelect again when needed. Thank you!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Darry from Edgewater, FL
- Parts Used:
- 49572A
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Nutdriver, Screw drivers
New dryer convert from Natural gas to liquid propane
Ordered the part, called a friend that is a LP worker. He came over and in less than 15 mins had the new orface and regulator plunger installed and another 10 mins to install new flex pipe and shut off valve and it works great. It was really easy I watched him do it and could of done it myself if I did not have a friend that could do it.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from El Paso, TX
- Parts Used:
- 49572A
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver, Wrench (Adjustable)
Changed the orfice to convert from natural gas to propane.
I just followed the instructions provided, after taking a long look as to whether it really applied to our dryer. Just take your time and install the unit as you removed it. We removed the unit by first removing gas line, then two screws on the side and it was out. Put on stopper, followed by switching out the orfice.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Robert from Wright City, MO
- Parts Used:
- 49572A
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 1- 2 hours
- Tools:
- Socket set
convert dryer from natural gas to LPG
Had no definative directions so kind of had to play it by ear. once I got the top and front off the directions that came with the part were spot on. My biggest problem was I guess I was a little over agressive with the drum and I pulled the tension pulley off the bottom. I had to drill a hole and bolt it back down because I couldnt get the little flanges to bend over enough to hold it. It works now but I havent done a load of clothes yet to make sure it will stay together
Was this instruction helpful to you?
Thank you for voting!