MGDC415EW2 Whirlpool Dryer - Instructions

We didn't even look at the instructions. Just rotated the handle until it snapped back into place.

New handle just snapped in - really easy. Have to compliment Part Select - I ordered handle one day and it was delivered the next day. Impressive!

I snapped the new handle into place, it took 2 seconds. The new handle was made thicker and stronger than original. Its unlikely I will be doing this repair again.

When I ordered the part over the phone was told it just snaps in. Not sure what it meant. Parts delivery was prompt. Looked at the part and it’s pisition on the dryer.And it really was very simple.

ordered a replacement handle - installed it myswelf

Lint can build up inside the dryer, and can cause a fire in EXTREME cases. If your model has a back panel that exposes the entire chute, this job is much easier. Unscrew the chute from the machine to remove it. Inspect and clean all the lint out, especially the bottom, next to the fan blower. The other version machine has a panel at the top that is welded on. Remove the two screws at the top corner of the rear bulkhead, where the chute is. Gently pull this inner panel away to free the top of the chute from the rear top panel. Then pull the chute down and out. Follow the reverse to complete the job.

Removed rear cover (6 screws) unpluged harness from motor control and removed same. Replaced motor control reinstalled harness. Replaced rear cover. Parts used motor control board.

Had no definative directions so kind of had to play it by ear. once I got the top and front off the directions that came with the part were spot on. My biggest problem was I guess I was a little over agressive with the drum and I pulled the tension pulley off the bottom. I had to drill a hole and bolt it back down because I couldnt get the little flanges to bend over enough to hold it. It works now but I havent done a load of clothes yet to make sure it will stay together

I just followed the instructions provided, after taking a long look as to whether it really applied to our dryer. Just take your time and install the unit as you removed it. We removed the unit by first removing gas line, then two screws on the side and it was out. Put on stopper, followed by switching out the orfice.

I pulled thee dryer out from the wall, shut off the gas & disconnected the gas line & the air vent, I then removed the fasteners from the upper end of the lint chute assembly (accessible from the top of the machine). I then tipped the machine over on to its front side making the back fully accessible. After removing the back cover, I removed the remaining fasteners holding the lint chute assembly in place & removed the part. I then removed the assembly only to find that the seals were not included in the package even though I had specifically asked about the seal when I called in & place my order. The response to my question was " seals are included that is why it is called an assembly." The end result was that I had to use alternate material & fabricate my own seals in order to complete the installation. As a result a repair which should have taken no more that 30 minutes, took over two hours.

Followed Directions included with Kit. Directions were right on. Have done other Range and Drier conversions in the past.

This did not require a "repair", just a replacement. I want to say that the response time and ease of ordering were very good. I would not hesitate to use PartSelect again when needed. Thank you!

Ordered the part, called a friend that is a LP worker. He came over and in less than 15 mins had the new orface and regulator plunger installed and another 10 mins to install new flex pipe and shut off valve and it works great. It was really easy I watched him do it and could of done it myself if I did not have a friend that could do it.