AEM407W2-PAEM402W2 Speed Queen Dryer - Parts

This part is located between the back of the drum and the rear dryer panel.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This drum support roller bracket and shaft assembly is a little over two inches long. It is made of metal.

This 1/4 horsepower gas or electric clothes dryer motor carries 120 volts, 60 Hz, and 5.5 amps. It also performs 1725 revolutions per minute. This motor is used for some gas and some electric clothes dryers.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

Part may differ in appearance, but functions same as original part.

This shaft is made to fit the center of the idler pulley wheel of many clothes dryers. It is less than two inches long, and is made of metal.

This arm is what attaches to the idler pulley wheel.

This hi-limit thermostat acts as a safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

Sold Individually.

The bracket is no longer included.

This 240 volt heating element is used for electric clothes dryers. Included with this element is a fuse kit consisting of a thermal fuse, a high limit thermostat, two wire leads, and four mounting screws.