DV330AGB (XAA) Samsung Dryer - Instructions

I removed the dryer top and saw that the belt was intact. (I had suspected the belt or something stuck in the exhaust fan or somewhere.) I watched a few youtube videos and took off the rest of the top plates and front door and inner structure that held the barrel. After i inspected and cleaned out the fan blades and exhaust areas, I looked at the pulley rollers (motor and idler rollers). The idler roller looked a little melted and chewed up. I replaced it with the new assembly. Also replaced the belt. Putting the barrel and new belt back on was harder for me than the videos indicated because the spring was very tight and the area to put my hands was small and didn't give me enough leverage. I eventually got someone to give me the third hand pulling the idling roller a little further over and the belt was back on. It didn't take me long to put the whole dryer back together. It is running fine now.

These are not instructions as much as warning that although it is a one-person job, the idler pulley assembly is not as easily manipulated with the barrel there. Doing the fix was straightforward: one screw holds it in place. The men in the videos seemed to have no problem with easily replacing the belt, but I needed help with the tight spring. Perhaps now that I've done it once, I could figure out how to reach around the barrel and yank the roller enough to replace the belt, but with the extra hand it took seconds and was super easy.

Followed the video on the website and finished it in a short time. Now it works like a new dryer.

Follow the video instructions.

It started off as supposed to be 5 minute job but took about 4 and a half hours (most of the time was vacuuming and cleaning the lint from inside the dryer as there was a lot of dryer lint built up including on the heater coils which the lint was charred black. So I went to install the cover filter and spring like in the video but my finger are larger so the spring fell off the ear/tab and fell down into the lint trap chute and into the flywheel that turns the drum so I had to remove the top and front of the dryer to retrieve the spring. That’s when I found even more lint but in the process of removing the front of the dryer I noticed one single screw holding the rear lint cover onto the dryer and so I removed that and pulled it out then with that rear cover in my hand I installed the cover filter and spring then reinstalled it. The video shows you to only remove the 3 screws to remove the front cover and then to stick your hands in the tight space and get the small spring and cover filter on and snap them into place. But if after you pull out the front cover then you will see a screw in the middle on the front side of the drum that is the the only thing holding g the rear cover in place just unscrew that and remove that cover and then you can replace the spring and cover filter and then you can put it back in and screw it back into place and then you won’t run the risk of dropping the spring down the chute like I did. If I did this trick it would have only taken me within 2 minutes to change the part...on a side note after finding all the lint I did, I would recommend taking the front and back of the dryer off and getting in there with a vacuum and cleaning it out once every year or two which will save you from a potential fire.

I still had to take it apart there was a small sock stuck in the fan that blowes the lent out my wife left the lent filter out one time. Your video was a great help. I'm a mechanic and it was easy thanks Anthony Ratto Tulipbike82@aol.com

Followed video and YouTube most was easy.... put the hooking up the belt took time

Took off the back of the dryer and replaced the thermistor. A $7 part that would have been a couple hundred dollars if we had to call a repairman.