GDG9900 Maytag Dryer - Parts

This part replaces older two terminal switches.

This front or rear dryer drum felt seal is seventy-nine and a half inches long.

This dryer door latch kit comes in two pieces: a door latch, and a door strike. It's used to help hold your door shut to your dryer.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

Sold individually. This bulb is a 7 watt appliance incandescent light bulb.This appliance light bulb is two inches long. It is used for many clothes dryers.

This idler shaft retaining ring is well under an inch long and is made of metal.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

This 115-volt, 60 Hz drive motor powers the drum in select Whirlpool and compatible dryers. It features a 1/4 horsepower output and a redesigned switch with updated wire terminals. Replace if the drye...

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.