MDE6000AZG Maytag Dryer - Parts

This idler shaft retaining ring is well under an inch long and is made of metal.

This timer knob insert cap is just over two inches in diameter. It is all white in color and is made of plastic.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperatu...

This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches around 183 degrees Fahrenheit, and will not cut in again. Like a house fus...

This thermal fuse is mounted on either the heating element or burner tube housing.

This terminal block assembly does not come with any hardware. It it three inches long and made of plastic and metal.

This heating element consists of a one piece metal tube and a coil. It carries 240 volts and is almost fifteen inches long with an approximate seven inch diameter. This element includes thermal fuse and heat shield.

This male door strike is just under an inch long. It is made of metal.