MEDB835DC3 Maytag Dryer - Parts

This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers,...

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over ...

Metallic screw that is less than an inch long. Does not include the plastic washer.

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one time use fuse, so when it does trip, you must replace it. The hi-limit thermosta...

This thermostat helps keep your dryer safe by turning off the heat if things get too hot. If your dryer’s overheating or not working right, this part might be the fix. It’s made to fit your model and ...

This is the replacement lint screen for your dryer. It is made of plastic and is approximately 14 inches by 9 inches. The lint screen traps unwanted lint and debris so your dryer can effectively dry y...

This shaft is for the front with right hand thread. Sold individually.

This part is located on the drum roller support shaft.

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately