MDG9357AWQ Maytag Dryer - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Robert from Dacula, GA
- Parts Used:
- W10169313
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Replaced pressure door switch
Too simple to describe.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Lloyd from Middlebury, IN
- Parts Used:
- 306436
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Pliers, Screw drivers
Broken latch
1.Separate the inner and outer door panels. Install the new latch thru the backer plate. 2. Remove the front panel to access the door catch. Remove the existing catch and replace.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- kevin from rockton, IL
- Parts Used:
- 306436
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Pliers, Screw drivers
P;atic latch in in door frame broke.
I removed two screws from the bottom panel,pulled bottom out, and lifted front panel off. Took pliers to back of the old latch to compress the expansion tabs, squeezed and removed. Pushed new one in untill it went through metal backing plate and snapped in place. Replaced the cover and screws. Opened door and took out two screws on the edge and one for the knob. Spread out door halves,used pliers to work out other latch part. Pressed in new part and reassembled. Works great for another twenty years!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Carl from Uncasville, CT
- Parts Used:
- W10169313
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers, Socket set
Dryer not turning on.
Researched the common problem with "dryer not turning on", and tested the top three problems. Removed the dryer front casing and door, unbolted front dryer plate. Used a volt meter on two of the temp gauges, which were fine. Removed the upper back plate of the dryer to the wiring for the knobs and buttons. Used the volt meter on the dryer start button, which was also fine. Went back around to the front and removed the door switch. Tested it with the volt meter and bingo. Replaced that part, dryer works like normal.
Was this instruction helpful to you?
Thank you for voting!