MDE7460AYQ Maytag Dryer - Parts

This idler shaft retaining ring is well under an inch long and is made of metal.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches around 183 degrees Fahrenheit, and will not cut in again. Like a house fus...

This thermal fuse is mounted on either the heating element or burner tube housing.

This terminal block assembly does not come with any hardware. It it three inches long and made of plastic and metal.

Sold Individually.

Sold Individually. This silver knob accepts a D-shaped shaft.

This heating element consists of a one piece metal tube and a coil. It carries 240 volts and is almost fifteen inches long with an approximate seven inch diameter. This element includes thermal fuse and heat shield.

This male door strike is just under an inch long. It is made of metal.