GDE19CD Maytag Dryer - Parts

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This high limit/safety thermostat is used on many of Maytag's brands of gas and electric clothes dryers. With this thermostat, a dryer's heating element will cut out if the internal temperature reache...

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This idler shaft retaining ring is well under an inch long and is made of metal.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This screw is sold individually.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

This motor comes with a redesigned motor switch and new wire terminals. This part runs at 1/4hp. It performs 1725 revolutions per minute and carries 4.5 amps and 115V.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This push button is just over three inches long. It is all black in color and is made of plastic.

This heating element consists of two pieces: a metal tube and a coil. It carries 240 volts and is approximately 17 inches long with an approximate 7 inch diameter.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.