MDG7658BWW Maytag Dryer - Parts

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperatu...

This conversion kit contains all parts needed to convert your gas dryer from natural gas (NG) to liquid propane (LP). This kit will work with some Samsung dryers as well. Use model # to ensure you are...

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches around 183 degrees Fahrenheit, and will not cut in again. Like a house fus...

This terminal block assembly does not come with any hardware. It it three inches long and made of plastic and metal.

Sold Individually.

Sold Individually. This silver knob accepts a D-shaped shaft.

This male door strike is just under an inch long. It is made of metal.

This timer cap is chrome in color.

This part is the replacement idler spring and rubber dampener for your dryer. The package comes with both the spring and the dampener. The spring is made of metal and is approximately 4 inches long fr...