MDE14PDADW Maytag Dryer - Parts

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This screw is sold individually.

This blower wheel does not come with a spring clamp, but it does have twenty fins and it is designed to fit a 3/8 of an inch motor shaft.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches around 183 degrees Fahrenheit, and will not cut in again. Like a house fus...

This thermal fuse is mounted on either the heating element or burner tube housing.

This terminal block assembly does not come with any hardware. It it three inches long and made of plastic and metal.

This male door strike is just under an inch long. It is made of metal.

Sold Individually.

This heating element consists of a one piece metal tube and a coil. It carries 240 volts and is almost fifteen inches long with an approximate seven inch diameter. This element includes thermal fuse and heat shield.

This part is the replacement idler spring and rubber dampener for your dryer. The package comes with both the spring and the dampener. The spring is made of metal and is approximately 4 inches long fr...

This heating element consists of a one piece metal tube and a coil. It carries 240 volts and is almost 14 inches long with an approximate 6-1/2 inch diameter. Element does not include a thermal fuse or a heat shield.

10 - 16 x .375