GDE7800 Maytag Dryer - Parts

This dryer door latch kit comes in two pieces: a door latch, and a door strike. It's used to help hold your door shut to your dryer.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This high-limit thermostat helps protect your dryer from overheating by cutting power to the heating element at 200°F and resetting at 170°F. It features two 1/4-inch male terminals and is compatible ...

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This idler shaft retaining ring is well under an inch long and is made of metal.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This screw is sold individually.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

This 115-volt, 60 Hz drive motor powers the drum in select Whirlpool and compatible dryers. It features a 1/4 horsepower output and a redesigned switch with updated wire terminals. Replace if the drye...

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

Made for use with series 08 and later gas and electric clothes dryers, this pre-stretched heating element coil carries 240 volts.