DG26CA Maytag Dryer - Parts

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

This 115-volt, 60 Hz drive motor powers the drum in select Whirlpool and compatible dryers. It features a 1/4 horsepower output and a redesigned switch with updated wire terminals. Replace if the drye...

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

A dryer's idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.

This conversion kit contains all parts needed to convert your gas dryer from natural gas (NG) to liquid propane (LP). This kit will work with some Samsung dryers as well. Use model # to ensure you are...

Sold Individually.

This thermal fuse mounts on your dryer's blower wheel housing. It will cut out once your dryer's internal temperature reaches 183 degrees Fahrenheit, and will not cut in again. Like a house fuse, you ...

10 - 16 x .375

The blower housing seal makes an airtight seal between the blower housing and the blower housing cover in the dryer.

This part moves the clothes around inside your dryer and helps to direct the flow of hot during the drying cycle.

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.