Models > DE712 > Parts

DE712 Maytag Dryer - Parts

Jump to:

13 - 24 of 167
Keep searches simple, eg. "belt" or "pump".
This part replaces older two terminal switches.
In Stock
This front or rear dryer drum felt seal is seventy-nine and a half inches long.
In Stock
This dryer door latch kit comes in two pieces: a door latch, and a door strike. It's used to help hold your door shut to your dryer.
In Stock
This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...
In Stock
This high limit/safety thermostat is used on many of Maytag's brands of gas and electric clothes dryers. With this thermostat, a dryer's heating element will cut out if the internal temperature reache...
In Stock
This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.
In Stock
This idler shaft retaining ring is well under an inch long and is made of metal.
In Stock
Cycling themostats continually cycle the heating element off and on to maintain a constant inner temperature within the dryer. This particular cycling thermostat can be adjusted between 135 and 155 de...
In Stock
This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.
In Stock
$13.09
This screw is sold individually.
In Stock
This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.
In Stock
This motor comes with a redesigned motor switch and new wire terminals. This part runs at 1/4hp. It performs 1725 revolutions per minute and carries 4.5 amps and 115V.
In Stock
13 - 24 of 167