MDE16PSAZW Maytag Dryer - Parts

This part replaces older two terminal switches.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This high-limit thermostat helps protect your dryer from overheating by cutting power to the heating element at 200°F and resetting at 170°F. It features two 1/4-inch male terminals and is compatible ...

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This arm is what attaches to the idler pulley wheel. The grommet no longer comes with the part as it has been updated by the manufacturer.

This idler shaft retaining ring is well under an inch long and is made of metal.

This thermostat kit helps regulate your dryer’s temperature by cycling the heating element on and off. It’s adjustable between 135°F and 155°F and reactivates the heat when the temperature drops by 20...

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This push button is just over three inches long. It is all black in color and is made of plastic.

This part has a D-shaped motor shaft and this motor runs at 1/4 horsepower and carries 4.5 amps.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.