LDG7304AGE Maytag Dryer - Parts

This part is used to help the belt to rotate the drum. It is white and made of plastic with a metallic bearing in the center.

This part replaces older two terminal switches.

This front or rear dryer drum felt seal is seventy-nine and a half inches long.

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the m...

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

This idler shaft retaining ring is well under an inch long and is made of metal.

This roller shaft hex nut measures well under an inch long. It is made of metal and is used for Maytag brand clothes dryers.

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperatu...

A dryer's idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.