LDG18CA Maytag Dryer - Parts

This 115-volt, 60 Hz drive motor powers the drum in select Whirlpool and compatible dryers. It features a 1/4 horsepower output and a redesigned switch with updated wire terminals. Replace if the drye...

This sleeve is less than an inch in diameter. It is made of metal and is intended for use with the screw that holds the idler pulley of your clothes dryer.

This gray levelling leg foot pad is made of rubber and is just over an inch in diameter. Sold individually.

This high limit thermostat is about an inch and a half long. This thermostat will cut out when the internal temperature of your dryer reaches 240 degrees Fahrenheit, and cut back in when the temperatu...

A dryer's idler pulley wheel serves to help the belt to rotate the drum. This arm is what attaches to the idler pulley wheel.

Sold Individually.

The tumbler seal can be used for the front or rear. Sold individually.

This kit comes with two ceramic insulators.

10 - 16 x .375

The blower housing seal makes an airtight seal between the blower housing and the blower housing cover in the dryer.

This part moves the clothes around inside your dryer and helps to direct the flow of hot during the drying cycle.