11078103310 Kenmore Dryer - Parts

This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both h...

The door catch is a metal piece found on the inside dryer door, which helps to keep the door closed. If the catch is broken the door may not stay securely shut, which can result in the dryer not start...

This is a genuine OEM replacement igniter kit for your gas-heated clothes dryer. The silicon carbide igniter is used to light the gas that creates the heat in order to dry your clothes. If your dryer ...

It is important for your dryer to be properly leveled, as an unleveled one can cause excessive vibration and noise when operating, may not drain properly, and can cause excessive wear on various parts...

This is a genuine idler pulley wheel and arm for a dryer. The idler pulley wheel ensures the correct tension is on the drive belt to spin the drum. The arm is what connects to the idler pulley wheel a...

This part is the replacement single front panel clip for your dryer. It is made of metal and is approximately 2 inches long and ¾ inch wide. The front panel retainer clip is what holds the front panel...

Converts natural gas burners to liquid propane.

This part creates a seal around the door. High temperature adhesive is included.

This part is used to rotate the drum.

This screw is sold individually.

Sold individually.