110C66012011 Kenmore Dryer - Parts

This is a multi-use screw mostly used in dryers. It has a diameter of #10, length of one inch, and thread size of 16. Remember to follow safety practices and instructions provided in the manufacturer ...

Metallic screw that is less than an inch long. Does not include the plastic washer.

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

This shaft is for the front with right hand thread. Sold individually.

This hi-limit thermostat acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this piece will shut down power to the heating element.

This part seals between the blower housing and the blower housing cover.

This part is located on the drum roller support shaft.

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

This parts covers the bulb inside the drum.

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct.

The cover keeps garments away from the exhaust air duct and lint screen housing inside the dryer.