11069722800 Kenmore Dryer - Parts

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over ...

Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.

Sold Individually.

This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumbl...

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

This shaft is for the front with right hand thread. Sold individually.

This part is located on the drum roller support shaft.

This part seals between the blower housing and the blower housing cover.

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately

11-16 x 3/4 Sold individually.