11061652020 Kenmore Dryer - Parts

This is a multi-use screw mostly used in dryers. It has a diameter of #10, length of one inch, and thread size of 16. Remember to follow safety practices and instructions provided in the manufacturer ...

This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers,...

The blower wheel pulls air over the heat source, through the clothes drum, and past the thermostats, then pushes it out the exhaust duct. The blower wheel, which is usually plastic, may wear out over ...

Metallic screw that is less than an inch long. Does not include the plastic washer.

The thermal cut-off (fuse) is meant to trip at a higher temperature than that of a high limit thermostat. This is a one time use fuse, so when it does trip, you must replace it. The hi-limit thermosta...

This thermostat helps keep your dryer safe by turning off the heat if things get too hot. If your dryer’s overheating or not working right, this part might be the fix. It’s made to fit your model and ...

This part is the replacement motor pulley for your dryer. The motor pulley allows the dryer belt to run straight while the dryer is operating. If your motor pulley is damaged, your dryer may not tumbl...

The blower shaft is 1-5/8 inches long, while the drive shaft is 1-1/4 inches long.

This shaft is for the front with right hand thread. Sold individually.

This part is located on the drum roller support shaft.

This part is an electrical connector where you can attach wires. This part does NOT included the wires, screws, and nuts. Must be order separately