GEF331CS0 Gibson Dryer - Instructions

it was so easy using the video that you emailed me. I want to rebuild my whole drier now .

My husband died last year and I have learned to use the internet to fix a lot of things. I was so pleased to find your video instructions which gave me the confidence to repair my dryer, myself, for less than $40. Just like instructed I disconnected and pulled out my dryer from the wall. Pried off the top by using a small pry tool near the clips. As my dryer was close to a shelf that would support the raised lid I did not have to disconnect the ground wire on the back. I then pried off the wire connectors from the switch. Unfortunately one of them broke off the end of the wire so I had to replace with a new connector which I purchased from a local hardware store. (strip about a 1/2 of coating off the wire insert in the new connector and attach by squeezing with a pliers) Once that was done I put the switch in place by lining up the notches and twisting into position. I slid on the connectors. Correctly lined up the knob and pushed it in place. Then I reconnected the dryer to the outlet, gave it a turn and it started. Happy dance time! To be completely honest a helpful tip for retrieving a connector that falls down the side of the drum--chewing gum on the end of a 3 ft wooden dowel. Thanks again, you can be sure in the future I will be checking out your company when need arises.

This video by Steve Ash was spot on . In our case the white rear support bearing had melted and reformed around the shaft, preventing us from being able to pop the drum in the way described in the video. We used pliers to unscrew the screws on the rear clip from the back of the dryer. The rest of it worked exactly as described in the video. Our model was White-Westinghouse DE600ADD1, which is not a model listed on the PartsSelect website. However the part worked very well. The dryer runs really quite now.

-remove screws on top of dryer -check for clips on side -remove panel under control panel -remove screws (6) I think, holding control panel -disconnect door switch connector -remove 2 more screws holding front -you may have to lift the tub to allow the vent tube to clear for front removal - - Proceed with felt seal portion of repair - - - -GOOD LUCK You may need help.

You tube has quite a few videos that walk you right through the entire process. Due to the age of my dryer I replaced the belt and the Rear Drum Bearing kit while I had it apart. There were videos for all of it. Easy fix.

The belt arrived in 2 days. I cleaned the inside and it took no time to replace the belt. All I did is removed the front.The video was very helpful.Your magnet is on my refrigerator for future orders. Thanks.....Andy