MTMX050EF3WW General Electric Dryer - Instructions

Ordered new part, part came in, snapped in to place. Took less than 5 minutes, the hardest part was getting the part out of the package.

removed the old broken handle, and snapped the new one in place, total time; 10 seconds.

Snapped on the new on the new one. all done

Switch off the circuit breaker supplying power to the dishwasher.

Remove the 6 screws that hold the plastic face of the inside of the dishwasher door, and lift out the inside liner. This may be a good time to wash it down, as it is probably a little messy. It may also be a good idea to put something a little heavy onto the door to keep it laying in the open position as the springs will keep lifting it back up.

Remove the screw holding the spring device down over the interlock switches and the thin plastic cover and put aside ready for re-installing again later. The spring may have flattened a bit and it may be a good idea to bend the end open, just a little, to give it back some tension. This is the spring that activates the interlock switches when you latch the door.

Unclip the faulty Interlock Switch by pushing (with your fingers) the little plastic clip holding it in and lifting it out of its cradle. If the switch to be replaced is the one furthest from the machine (or nearest the top of the door) you will have to take the bottom one out first so that the clip can be released.

Using small pliers pull the electric connectors off the faulty switch and reconnect to the new switch in the same way that the faulty one was wired.

Snap the switch (or switches) back into place in the cradle.

Replace the spring activator along with the plastic sheeting and screw that back in.

Put the inside of the now clean door back down into place, making sure the on/off lever is inserted through the slot in the front of the door, and that the piece of Styrofoam is inserted back into position.

Screw the screws back in, starting with the one at the top center nearest the on/off lever and then work your way down the sides from top to bottom.

Switch the circuit breaker back on and give it a whirl. Enjoy!

First I turned off the breaker to the dishwasher. I then removed the bolts that held on the inner cover(note the two small bolts go on the bottom one on each side). I lifted the switch up and disconnected the wire clips from each side. I then put the new switch in place with the wires attached. Then replaced the cover and screwed it into place. Closed the door and flipped the breaker back on and turned the dish washer on and it started up. A very easy replaceable part.

It clicked right in. Thank you!

Pulled broken one out and inserted new one in slots and popped in place.

It just popped back in...the really really amazing thing is the part arrived the next day....and I could immediately get the dryer fixed..thank you so much...

Actually, my wife just unscrewed the part that was still there and screwed on the replacement handle: it was easy for her. Thank you for having the part!...James

The part arrived 24 hours after I placed the orer, even with the standard shipping. I just popped it in and problem solved.

The service was prompt and efficient. When the door handle arrived it was very simple to attached. it snapped right into place that was it. It took just a few moments.

new part arrived and had it installed and working in less than 3 minutes.

All that was needed when I got the new handle from Fed-ex, was simply to line-up the clips with the holes in the door and push in till everything snapped in place. It was very easy. It took longer to open the package than to attach the handle.

Handle was the exact replacement slipped it into the handle slots and pushed in to lock in place.

Removed handle from box...walked into the laundry room...snapped part into the door panel. All done! Thanks for the prompt delivery.